If possible, try to check if the same functions (with the same media content, with the same connected hardware, and with the same player settings) work normally on other players of the same model. Try to use other media content or connect other hardware to check if the problem is caused by a specific kind of media content of a specific kind of connected hardware. Some player functions can work improperly or be not available due to a particular media content, a particular connected hardware, or particular player settings.Switch the player off, wait at least 60 seconds, then switch it on. It is possible that the device needs to be rebooted.Wait until the condensate evaporates, see 'Safety Measures' section, and then start using the player normally. It is possible that the temperature requirements were not observed, and there is condensate on internal parts.If the problem persists, it is quite probable that the player is not compatible or is partially compatible with the particular Digital A/V output equipment. If possible, try to connect the player to another TV/monitor/projector or AV receiver, since the problem may be caused by another equipment, and not the player or Digital A/V cable.If possible, try to change the mode of connection of the player to your Digital A/V output equipment: e.g., instead of connection through a receiver, connect directly to a TV set.If possible, try to use another Digital A/V cable.It is suggested to start with the lowest picture resolutions. You should test this by consecutive examination of video modes. Change of video mode to another one compatible with your TV set may help solving the problem. Your TV set may not support some video modes, or does it improperly. Try to switch on/off the sound transmission through Digital A/V output (player Setup menu, Sound setting section), sometimes it has a considerable effect on the situation.If the problem persists after switching to an analog connection, it shall mean that it is not related to Digital A/V output, but rather to your TV/monitor/projector. First of all, make sure that the problem is related to the Digital A/V output connection: try to use an analog connection to a TV/monitor/projector (e.g., component).This feature is not related to the above problems. Note: Reinitializing of Digital A/V video output of the player, which is performed when switching between the file browser and video playback (in the form of several second delay before playback start and return to the file browser) is an expected and normal player behavior with current firmware versions installed, it takes place with any Digital A/V output equipment. Color bars or other strange effects on screen.

Problems with sound on a TV set (during sound transmission through Digital A/V output).Periodic warning on the TV/monitor/projector screen about video mode change during video playback or operation of the file browser.Periodical disappearing or jumping of picture during video playback or operation of the file browser.Digital A/V output connection is not available at all, although everything is properly connected and configured.This kind of troubles results from bad compatibility of the player with some models of Digital A/V output equipment. TROUBLE: Digital A/V output connection does not function or function improperly (picture disappears/ jumps, etc). SOLUTION: Please refer to the 'Remote Control' section for proper operation of the remote control. TROUBLE: The remote control does not work or works improperly. Refer to the Quick Setting of Video Output Mode. If you are sure that the equipment is properly connected (using appropriate cable connected to appropriate sockets), try to adjust video output settings using the MODE button of your RC. SOLUTION: If during 60 sec after switching on there is still no picture on the screen, and the player power indicator is lighted, most probably the video output parameters of your player or video input of your TV/monitor/projector are incorrect. TROUBLE: The player turns on, but there is no picture. Wait at least 60 seconds before switching on the player. SOLUTION: Check if the player is connected to AC mains.

Kartina tv player